NSE7_SDW-7.0 Exam Dumps - PDF Questions and Testing Engine
NSE7_SDW-7.0 Dumps - The Sure Way To Pass Exam
One of the main objectives of the Fortinet NSE7_SDW-7.0 Exam is to validate the candidate's knowledge of SD-WAN technology and the benefits it offers. SD-WAN is a popular technology that allows organizations to improve the performance and reliability of their WAN connections by leveraging multiple types of transport, including broadband, LTE, and MPLS. Fortinet's Secure SD-WAN solution provides additional security features, such as firewalling, IPS, and anti-malware protection, to help organizations secure their WAN traffic.
NEW QUESTION # 23
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)
- A. http
- B. dns
- C. twamp
- D. icmp
Answer: A,B
Explanation:
Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7
NEW QUESTION # 24
Which two tasks are part of using central VPN management? (Choose two.)
- A. You can configure full mesh, star, and dial-up VPN topologies.
- B. You configure VPN communities to define common IPsec settings shared by all VPN gateways.
- C. You must enable VPN zones for SD-WAN deployments.
- D. FortiManager installs VPN settings on both managed and external gateways.
Answer: A,B
NEW QUESTION # 25
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
- A. get router info routing-table all
- B. get ipsec tunnel list
- C. diagnose vpn tunnel list
- D. diagnose debug application ike
Answer: D
Explanation:
IKE real-time debug - useful when debugging ADVPN shortcut messages and spoke-to-spoke negotiations.
* diagnose debug console timestamp enable
* diagnose vpn ike log filter clear
* diagnose vpn ike log filter mdst-addr4 <ip.of.hub> <ip.of.spoke>
* diagnose debug application ike -1
* diagnose debug enable
NEW QUESTION # 26
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
- A. When T_N1PLS_0 has a latency of 80 ms.
- B. When T_INET_0_0 and T_MPLS_0 have the same latency.
- C. When T_MPLS_0 has a latency of 100 ms.
- D. When T_INET_0_0 has a latency of 250 ms.
Answer: A
NEW QUESTION # 27
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan health-check
- B. diagnose sys sdwan sla-log
- C. diagnose sys sdwan intf-sla-log
- D. diagnose sys sdwan log
Answer: B
Explanation:
SD-WAN 7.2 Study Guide page 321 You can view the stored member metrics by running the diagnose sys sdwan sla-log command. Note that you must include the name of the performance SLA followed by the member configuration index number. To display the SLA logs per interface, you run the diagnose sys sdwan intf-sla-log command.
NEW QUESTION # 28
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Per-IP shaping mode
- B. Interface-based shaping mode
- C. Reverse-policy shaping mode
- D. Shared-policy shaping mode
Answer: B
Explanation:
Interface-based shaping goes further, enabling traffic controls based on percentage of the interface bandwidth.
NEW QUESTION # 29
Refer to the exhibits.
Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.
The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.
Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)
- A. On the sender FortiGate, duplication-max-num is set to 3.
- B. The ICMP echo request packets received over T_INET_0_0 and T_MPLS_0 were offloaded to NPU.
- C. On the receiver FortiGate, packet-de-duplication is enabled.
- D. The ICMP echo request packets sent over T_INET_0_0 and T_MPLS_0 were dropped along the way.
Answer: A,C
NEW QUESTION # 30
In a hub-and-spoke topology, what are two advantages of enabling ADVPN on the IPsec overlays? (Choose two.)
- A. It enables spokes to establish shortcuts to third-party gateways.
- B. It provides the benefits of a full-mesh topology in a hub-and-spoke network.
- C. It enables spokes to bypass the hub during shortcut negotiation.
- D. It provides direct connectivity between spokes by creating shortcuts.
Answer: B,D
NEW QUESTION # 31
Refer to the exhibits.
Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)
- A. Dead peer detection is disabled.
- B. The phase 1 configuration supports the network-overlay setting.
- C. FortiGate does not install IPsec static routes for remote protected networks in the routing table.
- D. FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.
Answer: B,C
NEW QUESTION # 32
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
- A. When T_N1PLS_0 has a latency of 80 ms.
- B. When T_INET_0_0 and T_MPLS_0 have the same latency.
- C. When T_MPLS_0 has a latency of 100 ms.
- D. When T_INET_0_0 has a latency of 250 ms.
Answer: A
NEW QUESTION # 33 
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
- A. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
- B. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- C. London generates an IKE information message that contains the Toronto public IP address.
- D. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
Answer: A,D
NEW QUESTION # 34
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set source 100.64.1.1.
- B. Set load-balance-mode source-ip-ip-based.
- C. Set priority 10.
- D. Set cost 15.
Answer: C,D
NEW QUESTION # 35
Refer to the exhibit.
Based on the exhibit, which action does FortiGate take?
- A. FortiGate brings down port5 after it detects all SD-WAN members as dead.
- B. FortiGate bounces port5 after it detects all SD-WAN members as dead.
- C. FortiGate fails over to the secondary device after it detects all SD-WAN members as dead.
- D. FortiGate brings up port5 after it detects all SD-WAN members as alive.
Answer: C
NEW QUESTION # 36
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
- A. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
- B. The sdwan_service_id flag in the session information is 0.
- C. Traffic does not match any of the entries in the policy route table.
- D. All SD-WAN rules have the default setting enabled.
Answer: B,C
Explanation:
sdwan_service_id is 0 = match SD-WAN implicit rule, study guide 7.0 page 120, 7.2 page 149 SD-WAN rules internally are interpreted as a Policy route, so when the traffic doesn't match with any policy route, it will be flowing by implict policy.
NEW QUESTION # 37
Refer to the exhibit.
The exhibit shows the details of a session and the index numbers of some relevant interfaces on a FortiGate appliance that supports hardware offloading. Based on the information shown in the exhibits, which two statements about the session are true? (Choose two.)
- A. The auxiliary session can be offloaded to hardware.
- B. The original direction of the symmetric traffic flows from port3 to port2.
- C. The main session cannot be offloaded to hardware.
- D. The reply direction of the asymmetric traffic flows from port2 to port3.
Answer: A,D
NEW QUESTION # 38 
Exhibit B -
Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
- A. port2 is referenced in a static route.
- B. port1 is assigned a manual IP address.
- C. port1 and port2 are not administratively down.
- D. port1 is referenced in a firewall policy.
Answer: D
NEW QUESTION # 39
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Specify a unique peer ID for each dial-up VPN interface.
- B. Use unique Diffie Hellman groups on each VPN interface.
- C. Use different proposals are used between the interfaces.
- D. Configure the IKE mode to be aggressive mode.
Answer: A,D
NEW QUESTION # 40
......
Fortinet NSE7_SDW-7.0 certification exam is designed to help organizations identify and hire qualified professionals who can implement and manage SD-WAN solutions. By requiring candidates to demonstrate their knowledge and skills in SD-WAN solutions, organizations can ensure that they have the right people in place to implement and manage their SD-WAN solutions. Fortinet NSE 7 - SD-WAN 7.0 certification is ideal for organizations that use or plan to use SD-WAN solutions to improve their network performance and security.
Pass Fortinet NSE7_SDW-7.0 Exam Quickly With Free4Torrent: https://pass4sures.free4torrent.com/NSE7_SDW-7.0-valid-dumps-torrent.html